Disposal hums but doesn't spin
We cut the power, clear the jam, and test the flywheel. If the motor is still good, we reset the unit and you're back in business.
When your kitchen sink stops draining and the disposal just hums, you need garbage disposal repair Annapolis MD homeowners call first. We diagnose the problem, fix it on the spot, and test the whole drain assembly before we leave. Whether it's a jammed flywheel in Eastport or a leaking flange in Parole, our licensed technicians handle disposal repair and replacement across Anne Arundel County.

Garbage disposal repair Annapolis MD is the diagnosis and correction of mechanical or electrical faults inside a kitchen waste disposal unit. That covers jammed flywheels, worn impellers, failed capacitors, leaking sink flanges, and motors that hum without spinning. We pull the unit, inspect the mounting ring and drain connections, test the circuit, and either repair the faulty component or replace the disposal with a correctly sized model. Most repairs take under two hours.
Annapolis homeowners deal with hard water, older plumbing, and kitchens that see heavy daily use. A disposal that's been grinding eggshells and coffee grounds for years will eventually seize or leak. We see plenty of garbage disposal fixing Annapolis MD calls after holiday cooking when a unit jams on bones or fibrous vegetables. If your disposal is not working, we can usually get to you the same day and have it running before dinner.
Our garbage disposal repair service covers the full job from diagnosis to cleanup. Here's what's included when you book with us.
We test the disposal, check the electrical connection, and inspect the drain and mounting assembly. We identify the root cause before recommending a fix.
If the disposal is jammed, we clear the obstruction and reset the unit. We also check the flywheel and impellers for damage.
We reseal flanges with plumber's putty, replace worn gaskets, and tighten mounting rings to stop leaks.
If the motor is burned out or the capacitor has failed, we replace the faulty component with a compatible part.
When repair isn't worth it, we install a new disposal, connect it to the drain, and test for leaks.
We clean up our work area and haul away the old unit if we replaced it. You're left with a working disposal and a clean sink.
When you call, we ask a few quick questions: Does it hum or is it silent? Is there a leak under the sink? Did you recently put something tough down the drain? Those answers help us bring the right parts and tools on the first visit, which saves you time and money.
Our technician arrives within the scheduled window, inspects the disposal, checks the electrical connection, and tests the drain for clogs. We use a leak detection camera when needed to check for hidden moisture around the flange. You get a clear explanation of what's wrong before any work begins.
We give you two numbers: the cost to repair and the cost to replace. If the motor is burned out or the unit is over 10 years old, replacement often makes more sense. If it's a simple jam or a worn gasket, repair is the better call. You decide, and we get to work.
Most repairs take 45 to 90 minutes. We replace worn parts, clear jams, reseal flanges with plumber's putty, and tighten mounting rings. If we're installing a new disposal, we connect it to the existing drain and test the P-trap for leaks. We use RIDGID and Milwaukee tools to get it done right.
Before we leave, we run the disposal with water, check for leaks under the sink, and make sure the drain flows freely. We clean up our work area and haul away the old unit if we replaced it. You get a walkthrough of what we did and how to keep it running.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Clears clogs in the P-trap and drain line that can mimic disposal problems.
Used for tightening mounting hardware and removing stubborn screws.
Finds hidden leaks under the sink and in the cabinet.
Loosens and tightens drain connections and mounting rings.
Seals the sink flange to prevent leaks.
Wraps threaded connections to ensure a watertight seal.
A homeowner in Eastport had a disposal that hummed but wouldn't spin. They tried the reset button and a plunger with no luck. The sink was backing up, and they were ready to replace the unit.
We cleared a jam caused by a piece of bone, reset the unit, and tested it. The disposal ran smoothly, and the drain flowed freely. The repair took 30 minutes and cost $150.
A Parole homeowner noticed water under the sink after using the disposal. The flange was leaking, and the cabinet floor was getting wet. They called us before mold set in.
We removed the old putty, cleaned the flange, and resealed it with fresh plumber's putty. We tested with running water and confirmed no leaks. The repair cost $200 and took 45 minutes.
A Cape St. Claire homeowner had a 15-year-old disposal that was noisy and leaking from the housing. Repair wasn't worth it, so we recommended a replacement.
We installed a new 1/2 HP disposal, connected it to the drain, and tested for leaks. The job took 90 minutes and cost $450, including haul-away of the old unit.
We see the same disposal problems over and over. Here are the most common issues we solve for Annapolis homeowners.
Ask a pro →We cut the power, clear the jam, and test the flywheel. If the motor is still good, we reset the unit and you're back in business.
We check the reset button, test the circuit, and diagnose the motor. If the motor is dead, we replace the unit.
We locate the leak, reseal the flange, or replace the unit if the housing is cracked. We test with water before we leave.
We clear the clog with a drain snake or hydro jetter and check the disposal for debris. We make sure the drain flows freely.
$150 - $600 depending on repair or replacement
We believe in upfront pricing. Typical 2026 pricing for garbage disposal repair in Annapolis ranges from $150 to $350, depending on the fault. A simple jam or reset is on the low end, while motor replacement or flange repair costs more. We give you a firm quote before we start, so there are no surprises. If you need affordable garbage disposal repair in Annapolis Maryland, call us for a straight answer.
Our pricing reflects the quality of parts and the skill of our licensed technicians. We don't cut corners, and we warranty our work. You get a repair that lasts, not a quick fix that fails in a month.
A jam or reset is quick and inexpensive. A burned-out motor or a cracked housing costs more because parts and labor increase.
If we need to replace a capacitor, flange, or motor, the cost of the part is added to the labor.
A disposal under a deep sink or in a tight cabinet takes longer to access, which can increase labor time.
If replacement is more cost-effective, we'll show you the numbers. A new disposal with installation typically runs $300 to $600.
“Our disposal started humming and wouldn't spin. I called in the morning and they had a technician out by early afternoon. He cleared the jam, showed me what caused it, and had it running in 20 minutes. Fair price, no upsell.”
Sarah M.Homeowner, Eastport
✓ Verified“The disposal was leaking from the bottom, so I knew it was probably shot. They gave me a quote to repair and a quote to replace. I went with the replacement and they installed a new one the same day. Clean work, and they hauled away the old unit.”
Tom R.Homeowner, Parole
✓ Verified“Our old house has quirky plumbing, and the disposal had been patched together by previous owners. Their technician sorted it out, replaced the flange, and made sure everything was sealed right. No leaks since. I'll use them again.”
Linda K.Homeowner, Historic District
✓ VerifiedThe most common cause is a jammed flywheel, usually from food scraps or a foreign object. The second most common is a tripped reset button or a burned-out motor. If your disposal hums but doesn't spin, it's jammed. If it's silent, check the reset button and the circuit breaker. If those don't fix it, call us for a diagnosis.
Most repairs run $150 to $350, depending on the fault and the parts needed. A simple jam or reset might be on the low end, while a motor replacement or flange leak repair costs more. We give you a firm quote before we start, so you know exactly what you're paying.
If your disposal is under 10 years old and the repair costs less than half the price of a new unit, repair usually makes sense. If it's older, leaking from the housing, or the motor is burned out, replacement is the better investment. We'll show you both options and let you decide.
We do. Our licensed technicians repair and replace garbage disposals across Annapolis and Anne Arundel County. We handle everything from simple jams to full unit replacements, and we warranty our work. Call us at +1 (831) 293-1204 to schedule service.
Don't let a broken disposal ruin your kitchen routine. Call us for same-day service and a repair that lasts. We're licensed, insured, and we warranty our work.
Schedule Repair +1 (831) 293-1204 →Call us at +1 (831) 293-1204 or email [email protected]. We answer the phone 24/7 for emergencies and schedule same-day or next-day visits for non-urgent work. Tell us what's wrong and your address, and we'll give you a time window and a price range before we head out.